1/2" Hose ID to 1/4" Male NPT 90 Degree Brass Elbow Fitting
90 degree brass elbow barbed fitting for extending air compressor air filters to a remote location.
Let customers speak for us
The mount fit my TrailRax Modular Rack perfectly. It was easy to install, and the Starlink worked flawlessly once it was attached. I love it.
This under seat compressor mount fits perfectly. Plenty of room for mounting the newer ARB Single Compressor and high quality in both fitment and coating for the mounting plate itself.
Highly recommend!
When we upgraded to the Roofnest Condor Overland 2 XL rooftop tent, we gained the additional space our growing family needed, but we also faced a challenge: limited rack space for mounting an awning. Even with the tent offset, there simply wasn’t enough clearance to deploy an awning without interference.
This adjustable bracket solution completely resolved that issue. Not only were we able to reposition the tent back to the center of the rack, but we can now deploy the awning with the tent open or closed, thanks to a simple adjustment using the T-handles and positioning holes.
While the bracket does require sourcing your own fasteners, it was a straightforward task with a quick trip to the hardware store and an Amazon order, all at minimal added cost. The build quality is excellent, robust with tight tolerances, and it remains impressively quiet even on rough off-road terrain.
This is the fourth product I’ve purchase from 813 Fabrication and Design, and it’s clear how much thought and testing go into each design. I’m confident this bracket will serve our camping family well for many adventures to come.
Just installed my Luna Light accessory mount a few days ago in the bed area of my Canopy Camper. Quick and easy install. Using it for a 6 inch USB fan. Got tired of trying to hang the fan in one of the pockets of the ceiling storage. Another winner from 813 Fabrication.
Fast shipping and product was as described and of high quality
These panels work great! Just make sure to mark twice before drilling for the Rivet Nut! Tape all three panels up and adjust as necessary before making your first insertion for Rivet Not.
Just had a canopy camper installed and moved my reverse camera from the license plate to its new location above the rear door. Looks like factory and wow what a perfect fit. Should be part of every Alucab setup from the factory. Simple to do and just gets your camera to the next level. Great visibility!
Amazing, fit was perfect just what i needed for the clean look!
It just perfect to have cleaner look at my setup.
Great product here , really helped to clean up my engine compartment
Tried to design my own using hdmw poly (aka cutting board) but not easy to clear all the bits and bobs. Then I ran across this! Took all of 2 minutes to install, including raising the hood. Looks great! And they shipped it FAST!
Good quality
The joolca heat shield fit great after a slight trim of the top vent. Haven’t got to test it yet but I’m sure it will work great for my application.
The infill panels are better quality than the stick originals and they allow me to use a huge amount of otherwise wasted space
